Tower Body: All of the tower is produced with epoxy painted galvanized steel. Drop Holders: Holders made of plastic material drops through a special form of water droplets in the air download the minimum holding water loss. Filling Material: It uses bugudi filling material which keeps water and air contact at maximum level.It is resistant to high water temperatures and has low lime retention. Radial Fan: Fans, swept rare birds or pre-curved are two kinds. Fan and shaft dynamic balancing is and in a shaft, two bearings on the bed. Fan and electric motors are only on a pedestal. Inside of the fan the foreign substances from entering to prevent suction to the wire cage has been applied. Electric Motor: The electric motor with suitable power rating IP54 drives the radial fans by means of the belt pulley mechanism. Belts V shift. The pulleys are tightening bushing casting pulleys. The pulleys are suitable for DIN2211, TS 148. Fountains The polypropylene fountains on the return pipe combine the air and water contact at the maximum level, ensuring that the water flows down homogeneously from the top of the hull. Water Feeding Flotator: To accommodate evaporation and drifting water losses, a suitable flushing feeder was installed. Emergency and overflow connections are available for safety.